Angle Brackets – Zinc Plated

Angle brackets are suitable for supporting or bracing purposes and are zinc plated for added protection.

Need help installing our lipped brackets outside, check out our DIY video with 5 easy steps for installation.

Product Code	A (mm)	B (mm)	C (mm)	Thickness (mm)	Load Rating
AZ04	50	50	20	3.5	100
AZ05	75	50	20	3.5	45
AZ06	75	75	20	4	50
B11473	75	50	140	3.5	not tested
B11474	75	50	240	3.5	not tested
AZ07	100	75	20	4	150
AZ08	100	100	20	4	75
B11470	100	100	40	3.5	not tested
AZ09	125	100	20	4	75
AZ10	125	125	20	4	75
AZ11	150	125	20	4	40
AZ12	150	150	20	4	25
B11462	150	150	75	4.5	not tested
AZ14	200	150	25	4.5	30
AZ414	200	150	40	4	45
AZ418	250	200	40	4.5	75
AZ422	300	250	40	4.5	30

Load rating test specifications:

Load rating tested at 415mm distance between 2 brackets
Bracket is fastened to wall using shortest side of bracket
Brackets tested in the orientation below:

Weight capacity of all shelf brackets will always be dependent on the fixing to the wall, distance between brackets and the condition of the wall, the brackets are being fitted to. Weight should be distributed evenly across shelf.

Angle brackets are suitable for supporting or bracing purposes and are zinc plated for added protection.

Features

For bracing or added support
Zinc plated for added protection
Available in a variety of sizes
Predrilled for fasteners

Important:

Brackets should only be attached to wall studs if attaching to plaster board walls, or brickwork/masonry (not mortar or grouting).
Appropriate heavy duty fasteners should be used.
Do not use plastic wall plugs to fix brackets to walls under any circumstances.
Make sure the bracket is securely fixed to the wall and all screws are fastened tightly.

The information provided herein corresponds to our knowledge on the subject at the date of its publication. This information may be subject to revision as new knowledge and experience becomes available. The data provided falls within the normal range of product properties and relate only to the specific item designated. The data provided should not be used to establish specification limits or used alone as the basis of design; they are not intended to substitute for any testing you may need to conduct to determine for yourself the suitability for your particular purposes. Since RCR cannot anticipate all variations in actual end-use conditions, RCR makes no warranties and assumes no liability in connection with any use of this information.